Setting Up The Compressed-Air Motor En; Adjusting The Proximity Switch En - Abicor Binzel BRS-LCi Betriebsanleitung

BRS-LCi
6.6 Setting up the compressed-air motor
Clamping device
1
Gas nozzle
2
Setting up the compressed-air motor
Fig. 7
1 Loosen the motor clamping in the guide block (4) by removing the screws (3).
2 Pull back the compressed-air motor (5) in its mount.
3 Place the required distance sleeve (7) on the milling cutter (6).
4 Move the torch with the gas nozzle (2) to the clamping position.
5 Keep the guide block (4) in the lower position (stroke at bottom).
6 Place the compressed-air motor (5) against the gas nozzle (2) with the distance sleeve (7) placed on
top .
7 Fasten the adjusted motor position by means of the screws (3).
8 Move the torch out of the clamping device and remove the distance sleeve (7) from the milling cutter (6).
6.7 Adjusting the proximity switch
NOTE
• Observe the clearance (6-9 mm) between the proximity switch (1) and the retaining sheet (3).
• The proximity switch is equipped with an LED for controlling the switching output.
Proximity switch
1
Transmitter disc
2
Adjusting the proximity switch
Fig. 8
1 Loosen the screws (4).
2 Move the retaining sheet (3) vertically in the area of the elongated slot.
3 Adjust the proximity switch (1) to the center of the transmitter disc (2).
4 Fasten the retaining sheet (3) by means of screws (4).
1 2
7
6
5
Screws
3
Guide block
4
1
5 4
Retaining sheet
3
Screws
4
3
4
Compressed-air motor
5
Milling cutter
6
2
3
Screws
5
6 Putting into operation
Distance sleeve
7
EN - 11