Start Screen For Fsa System Software - Bosch FSA 720 Betriebsanleitung

en 22 | FSA 720 | Operation
5. Operation
5.1 Notes on measurement
DANGER – Risk of electric shock if mea-
surements are taken on motor vehicles
without connecting cable B–!
Measurements taken with connecting cable
B– not connected to vehicle ground or the
negative post of the battery will result in
injury, heart failure or fatal electric shocks.
¶
For all measurements, connect the
FSA 720 by way of connecting cable B – to
vehicle ground or the negative post of the
battery.
DANGER – Risk of electric shock from ex-
cessively high measurement voltage.
The measurement of voltages in excess of
60 VDC/30 VAC/42 VACpeak using Multi
measurement leads CH1 / CH2 will result in
injury, heart failure or fatal electric shocks.
¶
Never use Multi measurement leads CH1 /
CH2 to measure mains or similar voltages.
!
Measurements with FSA 720 are only permitted in a
dry environment.
!
The FSA 720 is not to be used for checking isola-
tion from the supply on electric and hybrid vehicles.
Measurements on high voltage capacitator ignitions
are not permitted, as voltage values above 300 Volt
are present for this ignition type.
!
Measurements on the CRI Piezo are only permitted
with special adapter cables (optional accessories).
!
The measuring probes included in the test prod set
(1 687 010 153) can only be used for measurements
below 30 volt.
|
1 689 979 894 2014-08-28
General procedure for measurements on the vehicle:
1. Switch off the ignition.
2. Connect the FSA 720 with battery (B–) or motor
mass via connecting cable B–.
3. Connect required measuring lines to the vehicle.
!
Do not hold the measuring lines with your hand dur-
ing measurement.
4. Switch on ignition.
5. Perform measurement.
6. Switch off the ignition after measuring.
7. Disconnect measuring lines on the vehicle.
8. Disconnect connecting cable B–.
"
Measurement complete.
5.2 Diagnostics Software Selection DSA
You can do the following with DSA:
R
Run Bosch applications (also automatically).
R
Perform interface configurations.
R
Select language of DSA and Bosch applications.
R
Install software.
R
Release component test and vehicle-specific
information.
R
Update customer and vehicle data.
R
End Bosch applications.
Further information is available in the DSA online help.
5.3

Start screen for FSA system software

i
If several applications are open the "FSA system
software" may be impaired in terms of software
speed.
Robert Bosch GmbH