Installation; Installing The Control Unit - Kessel Aqualift 230V Mono Einbau- Und Betriebsanleitung

4

Installation

4.1

Installing the control unit

Disconnect the mains plug and open the housing; to do
this, undo both screws (turn anti-clockwise) and lift up the
housing cover.
Mount the housing in the planned place; to do so, use
both fixing options.
If planned, feed the USB connection out of the housing,
"Further connection possibilities" .
Close the housing cover and tighten both screws (clock-
wise).
Sensor variants
KESSEL control units are preconfigured for standard assign-
ments, but also allow numerous accessories to be retrofitted
and/or the installation of, for example, application-specific
sensor configurations or communication interfaces.
Connection types for control units
plug-in ready, preassembled cables (e.g. Schuko earthed
safety plug)
preassembled external connections on the underside of
the control unit (e.g. pressure hose inlet, connector). If a
spacer ring is not fitted, it is particularly important to note
and comply with specified torque!
preassembled or enclosed cable glands for cable pas-
sage (e.g. M16). The wire ends must be fed through here
up to the connection terminals on the printed board.
KESSEL 230V control units are generally delivered plug-
in ready with preassembled mains cable (Schuko earthed
safety plug).
Type
A Cable gland
B Connector (large)
C Connector (large)*
D Connector (small)
E Inlet, pressure hose
F Openings with blind
plugs
*Duo versions only
24 / 108
Type of conductor
Mains
Pump 1
Pump 2*
Alarm probe
Submersible pressure
switch (pipe)
alternative sensor configura-
tions, opt. Accessories
010-910_01