Configuration Menu; Parameter Level - Nouvag MD 30 Bedienungsanleitung

7.8
In the Configuration Menu the user can customize the device after his favor. The parameters are organized in
different levels. The following information and parameters are stored in there.
Exit from Configuration Menu:

Parameter Level 1

Group/Parameter
Software/Version
Hardware/Serial number MB
Date-Time/Date format US
Date-Time/Date
Date-Time/Time
Backlight/brightness (0. .10)
Programs/Number of programs
Operating hours/MD 30
Operating hours/Motor 1
Operating hours/Motor 2
Operating hours/Pump
Error memory/ 1 – 8
16
Downloaded from www.Manualslib.com

Configuration Menu

• Software version
• Mainboard serial number
• Date and Time
• Display illumination
• Number of programs
• Operating hours MD 30
• Operating hours Motor 1
• Operating hours Motor 2
• Operating hours of irrigation pump
Be cautious when changing parameters. Unusual behavior of instruments while operating may provoke
false reactions and jeopardize the patient.
Every setting and the new behavior of the instrument has to be verified and tested.
Access to Configuration Menu:
• Press "Enter" key for 3 sec. until you hear a long tone.
The right arrow " > " in the information line on the display indicates that you're in the Configuration
Menu.
• With "Select ▲" or "Select ▼" choose the desired parameter.
• Push "Enter" to go to the sub menu.
• To change the value press "Select ▲" or "Select ▼"
• To confirm the changes made, press "Enter" for one sec., until you hear a short tone.
• To abort the settings made press "Enter" briefly, the setting returns to its previous value.
• To leave the Configuration Menu press "Enter" for 3 sec., until you hear the long tone.
Rights
read
read
read/write
read/write
read/write
read/write
read/write
read
read
read
read
read
manuals search engine
• Error-messages (the last 8)
• Activation of available handpieces
• Speed limitation for each handpiece
• Range of action of AS mode
• Pump behavior
• Motor behavior for 4 different motors
• Behavior of torque at reverse mode
• Reset to factory default
Factory Definition
VX.XXXX Shows current software version
XXXXXXXXX Shows serial number of the main board
no Set to US Date format
– Change current date
– Change current time
9 Display brightness, changeable: 0, ... , 10
10 Number of activated Programs: 3, ... , 10
0 Shows operating hours of MD 30
0 Shows operating hours of motor 1
0 Shows operating hours of motor 2
0 Shows operating hours of pump
0 8 Error messages in chronological order.
MD 30 Operating Instructions, Art. No. 31686, V45/12
MD 30