Step 4: Setting The Torque; Step 5: Setting The Pump Supply Quantity - Nouvag MD 30 Bedienungsanleitung

7.4.4
7.4.5
14
Downloaded from www.Manualslib.com

Step 4: Setting the torque

Once the speed has been selected, the torque can be determined from the corresponding torque range.
Depending on the speed, the torque mode AL or AS is applied.
For information on AL and AS mode, see Chapter "7.5 Speed reduction AL (Automatic Limiter)" and
Chapter "7.6 Torque limit function: AS (Automatic Stopper)"
Press the "Torque" keys "▲" to increase or "▼" to decrease the maximum torque. By pressing the key
continuously the torques are shown in fast forward mode.
The following handpieces run on fixed torque only (6 Ncm) and cannot be changed.
● Micro Compass Saw MSS 5000
● Micro Oscillating Saw OMS 5000
● Micro Sagittal Saw MOS 5000

Step 5: Setting the pump supply quantity

Press the "Pump" keys "▲" to increase or "▼" to decrease the pump supply quantity. By pressing the key
continuously the values are fast forwarded.
Minimum und maximum of pump supply quantity as well as operating steps can be adjusted in the
Configuration Menu (refer to «7.8 Configuration Menu, Parameter level 2, Pump»).
To activate or deactivate the pump, press both "Pump" keys at the same time,
"Pump ▲ + ▼", or use the foot switch
manuals search engine
● Mucotome
● Kirschner Handpiece
.
MD 30 Operating Instructions, Art. No. 31686, V45/12
MD 30