Mesto 3270 Gebrauchsanleitung Seite 16

EN
Preparation
Observe the instructions in the section entitled „Safety".
The device must be in an upright position.
into the tank.
1. Pull up the red button on the piston pressure gauge [8] until all excess pressure is
released from the tank. (Fig. 3)
2. Press the piston rod with handle [10] down and turn it counterclockwise.
3. Unscrew the pump [2] from the tank. (Fig. 6)
+
4. Add the spraying liquid to the tank [1]. (Fig. 7)
6. Screw the pump [2] into the tank. (Fig. 8)
7. Press the piston rod with handle [10] down and turn it counterclockwise.
8. Generate the desired pressure
+
9. Press the piston rod with handle [10] down and turn it counterclockwise.
Spraying
Observe the instructions in the section entitled "Safety".
Operate the device only while it is vertical or suspended upright and nearly vertical.
Avoid allowing drops of spray to drift onto areas that are not being treated.
Observe the instructions of the spray product manufacturer!
1. Hang the device over your shoulder. (Fig. 11)
+
3. Make certain the optimum spraying pressure is set
gauge [8] (Fig. 10)
Spraying pressure
1.5 bar (21.8 psi)
2.0 bar (29.0 psi)
3.0 bar (43.5 psi)
Table 2. Dependence: Spraying rate – spraying pressure
4. If the spraying pressure decreases more than 0.5 bar (7.3 psi)
pump some more.
+
Spraying rate with hollow cone nozzle (original equipment)
16
(Fig. 7)
(Fig. 9)
in tank (Fig. 10).
0.48 l/min
0.56 l/min
0.69 l/min
ENGLISH
(Fig. 12)