iSi Thermo XPress Whip.PLUS Gebrauchsanleitung Seite 25

Disinfection
All product parts which come into contact with
food can be cleaned as normal and then disin-
fected. Observe the appropriate instructions for
use for commercial cleaning and disinfectant
agents.
Interim Cleaning
The decorator tip and nozzle adapter can be
removed at any time for periodic cleaning or it
can be rinsed with water while attached to the
device.
Quick Cleaning
1. Operate the lever until the device is com-
pletely empty and depressurized. Remove
the device head from the device.
2. Fill the device with 1 litre of warm water
and close it with the device head. Shake
the device 2-3 times vigorously and put it
into operation with one iSi charger (see also
"Operating Instructions", steps 3 to 8).
3. Empty the device quickly by firmly and con-
tinuously operating the lever and ensure that
the device is depressurized.
4. Unscrew the lever, unscrew the push button
from the device head and remove the device
head.
5. Disassemble the iSi Thermo XPress Whip plus
into the individual product components.
NOTE: Quick cleaning is not a replacement
for thorough cleaning.
Storage.
If the iSi Thermo XPress Whip plus is not going
to be used again immediately, allow the com-
ponents to air dry in a clean place. Store the iSi
Thermo XPress Whip plus with all of the pieces
disassembled and only handle clean (disinfected)
parts with clean hands.
NOTE: Observe valid food hygiene
regulations.
15
EN