Program Cvs - PIKO SmartControl light Kurzanleitung

System
light
the key, the function turns off.
With the [ and [
[ key.
You can change the data format by pressing and then use the [ and [
your selection by pressing [
higher the number of speed steps the more precisely you can control the train between a halt and its
top speed. Note that not all locos or decoders can accept more than 14 speed steps.
If you want to save the data set, press the [ key to leave the menu.
If you want to delete a selected loco data set, press the [stop/delete key.
By pressing [lok or [mode you can leave the menu without saving the changes to the loco data.

3.3. Program CVs

If there is a programmable DCC loco on the programming track and the menu point "CV - PROG.
TRACK" is selected, you can select and program all CVs (C V
1,024. Please refer to your decoder instruction for more information about the respective CVs and their
range of values.
After pressing [ key.
The current value of the CV will now be read and displayed after "2= VAL.:".
Now press [ key. The
programming will be executed automatically.
The result of the programming process will be displayed in the bottom line after a few seconds.
"PROG: OK" - programming successful "PROG: ERROR" - programming failed "PROG: NO LOCO"
- no loco on the programming track "PROG: SHORT" - short circuit of the loco or on the programming
track.
By pressing the [lok or [mode key you can leave the programming menu.
24