cecotec Conga 3390 Bedienungsanleitung Seite 33

ENGLISH
returns to the starting point in an inward spiral motion again. If the robot bumps into an object,
it will finish the cleaning cycle moving in the opposite direction in a spiral motion.
Manual mode
The robot can be manually controlled with the direction arrows on the display.
The robot will move in the selected direction as the arrow is being pressed.
It will also clean according to the suction power level and water intensity level selected on the
App home display.
Twice mode
When this mode is activated, the robot will first clean in Edge mode, then will carry out an
organized cleaning cycle in zig zag motion, then Edge mode again and another organized
cleaning cycle in zig zag motion. Once it has finished, it will return to the charging base, and if
it runs out of battery before finishing, it will recharge and then resume cleaning until finished.
This mode can only be activated during Edge, Scrubbing, Spiral and Smart Area modes.
Scrubbing mode
This robot also features Scrubbing function. When this mode is activated, the robot moves in a
swaying motion, simulating real scrubbing moves. It starts off by Edge mode, then carries out
an organized scrubbing cycle in zig zag motion, and finally returns to the charging base taking
the straightest way and memorizing the route. If it runs out of battery before finishing, it will
recharge and the resume cleaning until finished.
Spot cleaning mode
This mode can only be activated with a previously saved map. The user must select a specific
spot in the map, and the robot will clean a 2 x 2 m area around the selected spot. Once it has
finished cleaning it, it will smartly return to the charging base, taking the straightest way and
memorizing the route. Only one specific spot can be selected at a time.
Restricted Area
This mode can only be activated with a previously saved map. This mode allows setting areas
manually where the robot will not be allowed to clean. It starts cleaning outside the selected
area in Edge mode and then carries out an organized cleaning cycle in zig zag motion. The user
can set as many Restricted Areas as desired and choose the size of each of them.
Smart Area
This mode can only be activated with a previously saved map. This mode allows setting
specific areas that you want the robot to clean, without having to clean the whole surface. It
first carries out a cleaning cycle in zig zag motion inside the delimited area. The user can set as
many Smart Areas as desired and choose the size of each of them.
32