Crown CT13576 Originalbetriebsanleitung Seite 17

Symbol
Power tool designation
This power tool is designed for conducting various
grinding operations (removal of burrs and sharp edg-
es, etc�) with corundum grinding attachments�
Speed adjustment enables use of a wide range of
grinding attachments, like grinding discs, polishing
discs, emery tapes, etc� Using additional attachments
and appliances widens the power tool application
area�
Meaning
Wear a dust mask�
Disconnect the power tool
from the mains before instal-
lation or adjustment�
Movement direction�
Rotation direction�
Locked�
Unlocked�
Double insulation / protec-
tion class�
Attention� Important�
A sign certifying that the
product complies with es-
sential requirements of the
EU directives and harmo-
nized EU standards�
Useful information�
Do not dispose of the power
tool in a domestic waste
container�
Power tool components
1 Lock nut
2 Spindle
3 Ventilation slots
4 On / off switch
5 Open spanner *
6 Collet chuck *
* Optional extra
Not all of the accessories illustrated or described
are included as standard delivery.
Installation and regulation of power tool
elements
Before carrying out any works on the power tool it
must be disconnected from the mains.
Do not draw up the fastening elements
too tight to avoid damaging the thread�
Mounting / dismounting / setting-up of
some elements is the same for all power
tool models, in this case specific models
are not indicated in the illustration.
Mounting of the collet chuck (see fig. 1)
• While holding spindle 2 with open spanner 5, un-
screw lock nut 1 with another open spanner 5 (see
fig. 1).
• Insert collet chuck 6 into the hole of the power tool
spindle 2�
• While holding spindle 2 with spanner 5, tighten lock
nut 1 by hand using no second open spanner 5�
Grinding attachment installation / removal
Make sure the grinding attachment shank
diameter corresponds to the inner diam-
eter of collet chuck 6.
• While holding spindle 2 with open spanner 5, slack-
en lock nut 1 with another open spanner 5�
• Insert the grinding attachment shank in collet
chuck 6 (when removing remove the grinding attach-
ment shank from collet chuck 6)�
• While holding spindle 2 with open spanner 5, tighten
lock nut 1 with another open spanner 5 (when remov-
ing do not tighten lock nut 1)�
Do not tighten the lock nut 1 without
grinding tools.
Initial operating of the power tool
Always use the correct supply voltage: the power sup-
ply voltage must match the information quoted on the
power tool identification plate.
English
17