Reolink Go PT Bedienungsanleitung Seite 4

5 5 E English li h
2. Wait a few seconds and a red light will
be on and solid for a couple of seconds.
Then it will go out.
and then go solid before going out. You
will hear a voice prompt "Network
camera has been successfully connected
to the network.
NOTICE: You may also run into the following situations:
Voice Prompt Camera Status
"SIM card cannot be
Camera cannot
1
recognized" recognize this SIM card.
"The SIM card is locked
Your SIM card has a PIN.
2 with a PIN. Please
disable it"
"Not registered on
network. Please activate
Camera fails to register
3
your SIM card and check
to the operator network.
the signal strength"
"Network connection Camera fails to connect
4
failed"
to the server.
"Data call failed. Please
The SIM card has run out
5
of data or APN settings
data plan is available or
are not correct.
import the APN settings"
Solutions
1. Check if the SIM card is facing
the reverse direction.
2. Check if the SIM card is not
fully inserted and insert it again
Put the SIM card into your mobile
phone and disable the PIN.
1. Check whether your card is
activated or not. If not, please call
your operator to activate the SIM
card.
2. The signal is weak at the current
position. Please move the camera
to a location with better signal.
3. Check if you are using the
correct version of the camera.
The camera will be in Standby
mode and reconnect later.
1. Please check whether the data
plan for the SIM card is still
available.
2. Import the correct APN settings
to the camera.
English 6