CLEANING AND CARE
Risk of burns!
Do not clean the appliance until it is cold.
Z
X
Before performing any cleaning and
Read the general safety information about cleaning in
Z
X
the chapter „Safety information".
Turn the appliance off.
Z
X
General recommendations
Do not use steam cleaners or direct jets of water.
Z
X
Never use scouring pads, steel wool, muriatic acid
Z
X
or other products which could scratch or mark the
surface.
Do not use products containing sands, alkalis, acids,
Z
X
chlorides, oven sprays or detergents normally used to
clean dishwashers.
Maintenance of Easy Clean treatment
The Easy Clean treatment is applied only to the stainless
steel surface of the cooktop.
It is strongly advised not to use more aggressive
Z
X
detergents and rough sponges that could irreversibly
damage the special protective treatment of the
cooktop, causing the stain formation and no longer
removable marks.
To remove any kind of stain, just use a smooth cloth,
Z
X
dampened with hot water.
For a stronger dirt, it is recommended to use common
Z
X
dish soap that, together with a cloth dampened with
hot water, will guarantee the perfect cleaning result.
MAINTENANCE AND REPAIR
In case of any operation problems, contact the Franke
Technical Service Centre.
Make sure that maintenance on electrical components
Z
X
is carried out only by the manufacturer or the
customer service.
Make sure that damaged cables are changed only by
Z
X
the manufacturer or the customer service.
FH CR 301 1TC / FH CR 302 2G / FH CR 604 4G /
FH CR 755 4G TC / FH CR 905 4G TC / FH CR 1204 3G TC
care:
Cleaning the appliance
Clean the hob after every use in order to prevent
X
X
food residues from burning on. Cleaning dried-on and
burnt-on dirt requires more effort.
To clean everyday dirt, use a soft cloth or sponge with
X
X
water. Follow the manufacturer's advice with regard
to cleaning agents. We recommend using protective
cleaning agents.
Immediately remove any foods with high sugar content
X
X
that spill onto the hob.
To prevent limescale stains from forming, always
X
X
thoroughly dry the appliance after going over it with a
damp cloth.
Remove grime with a damp cloth.
X
X
Clean the grates, burner caps and flame-spreaders
X
X
with hot soapy water, making sure to carefully dry
them. Do not clean in a dishwasher. Make sure the
gas outlet zones are perfectly clean.
The natural colour of the pot grids in the pot placing
X
X
section may alter over time due to the heat.
When contacting the customer service, please provide
X
X
the following information:
– type of fault
– appliance model (Art.)
– serial number (S.N.)
This information is given on the data plate on the booklet
or under the hob.
If the hob doesn't operate correctly, before calling
X
X
the After-Sales Service, refer to the Troubleshooting
Guide to determine the problem:
– 9 –
EN