Herunterladen Inhalt Inhalt Diese Seite drucken

mundoclima MUPR-H10X Benutzer- Und Installationshandbuch Seite 72

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 174
CAUTION
Before changing the filter or cleaning,
turn off the unit and disconnect its power
supply.
When removing filter, do not touch metal
parts in the unit. The sharp metal edges can
cut you.
Do not use water to clean the inside of the
indoor unit. This can destroy insulation and
cause electrical shock.
Do not expose filter to direct sunlight when
drying. This can shrink the filter.
Air Filter Reminders
Air Filter Cleaning Reminder
After 240 hours of use, the display window on
the indoor unit will flash "CL." This is a reminder
to clean your filter. After 15 seconds, the unit will
revert to its previous display.
To reset the reminder, press the LED button
on your remote control 4 times, or press the
MANUAL CONTROL button 3 times. If you don't
reset the reminder, the "CL" indicator will flash
again when you restart the unit.
Air Filter Replacement Reminder
After 2,880 hours of use, the display window on
the indoor unit will flash "nF." This is a reminder
to replace your filter. After 15 seconds, the unit
will revert to its previous display.
To reset the reminder, press the LED button
on your remote control 4 times, or press the
MANUAL CONTROL button 3 times. If you don't
reset the reminder, the "nF" indicator will flash
again when you restart the unit.
CAUTION
Any maintenance and cleaning of outdoor
unit should be performed by an authorized
dealer or a licensed service provider.
Any unit repairs should be performed
by an authorized dealer or a licensed
service provider.
Maintenance –
Long Periods of Non-Use
If you plan not to use your air conditioner for an
extended period of time, do the following:
Clean all filters
Turn off the unit and
disconnect the power
Maintenance –
Pre-Season Inspection
After long periods of non-use, or before periods
of frequent use, do the following:
Check for damaged wires
Check for leaks
Make sure nothing is blocking all air inlets and outlets
72
Turn on FAN function until
unit dries out completely
Remove batteries
from remote control
Clean all filters
Replace batteries

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis