Maintenance And Repair; Carburettor Setting; Air Filter - eder ESG-A56 Gebrauchsanweisung

EN
Figure 6
When performing work, do not hold the device over
your head and always use both hands.
When the motor is running, only set the knife head
only the log surface at operating speed.
Move the EDER Bark Stripper ESG-A56 quickly
back and forth over the log without applying
pressure

Maintenance and repair

Carry out all maintenance and repair work
described in this manual. Other work must be
performed by Eder Maschinenbau GmbH or by
authorized workshops.
Original spare parts must be used. They can be
ordered directly from Eder Maschinenbau or
authorised dealers.
Modifications to the device are prohibited, since
they could adversely affect your safety.
Do not adjust the support, V-belt or the knife/milling
head when the motor is running.
The V-belt must always be tensioned properly.

Carburettor setting

The carburettor was set at the factory.
Do not tighten the screws (1) and (2) (see figure 8)
too tightly to avoid damaging the carburettor.
Adjust the screw (1) so that the motor quickly
responds to powerful accelerations, but does not
normally function at the highest speed (CAUTION
MAX. MOTOR SPEED 13.200 rpms).
Downloaded from www.Manualslib.com manuals search engine
Figure 8
Legend (fig. 8)
1- Carburettor maximum speed adjuster screw
2- Carburettor idling adjuster screw
3- Idling adjuster screw
Adjust the screws (2) so that the motor quickly
responds to the gas pedal.
Screw (1) must be at least 1+1/8 revolutions and
screw (2) at least 1+1/4 revolutions from the stop.
Caution
If the setting is too low, the motor could seize.
Maximum speed 13.200 rpms.
Before setting the carburettor, you have to check
whether the air filter is clean. The setting cannot
otherwise be performed.
Caution
Do not touch the cylinder or exhaust. They are hot.

Air filter

If you remove the cover (2), you have access to the
air filter (figure 9).
Turn the switch (6) to the stop position (0) (to
remove the filter).
- Unscrew the ball handle (1) and remove the cover
(2).
- Unscrew the nuts (3) and remove the filter (4).
You can remove the dust from the filter surface by
tapping a corner of the filter against a solid surface.
To remove the dirt in the mesh, you have to open
the filter in the middle and brush is using a brush
soaked in petroleum or clean using compressed air.
43