Ryobi BD-336FL Bedienungsanleitung Seite 16

GB
F D E
ADJUSTMENTS
WARNING:
Do not attempt to modify this tool or create
accessories not recommended for use with this
tool. Any such alteration or modification is misuse
and could result in a hazardous condition leading
to possible serious personal injury.
WARNING:
Your screwdriver / flashlight charging cradle
should never be connected to power supply
when you are assembling parts, making
adjustments, cleaning, performing maintenance,
or when not in use.
Disconnecting your tools will prevent accidental
starting that could cause serious injury.
INSERTING/REMOVING BITS
See Figure 2.
Follow these directions when inserting and removing bits.
Fig. 2
A. COLLET
B. BIT
To insert bit: Insert shank end of bit into collet.
To remove bit: Remove bit when finished and place
in storage cradle.
ADJUSTING TORQUE (SCREWDRIVER)
See Figure 3.
Follow these directions when adjusting torque.
Fig. 3
A. TO INCREASE TORQUE
B. TO DECREASE TORQUE
Locate arrow on torque adjustment cap.
To increase torque: Turn torque adjustment cap
counterclockwise.
To decrease torque: Turn torque adjustment cap
clockwise.
I P NL S DK
English
ADJUSTING TOOL ANGLE
See Figure 4.
Follow these directions when adjusting tool angle.
Fig. 4
A. MOVE DOWN
B. PRESS
NOTE: To return tool to original position, press angle
MOUNTING CRADLE/CHARGER
See Figure 5.
Follow these directions when mounting the cradle/ charger.
NOTE: Temporarily place the tools in the cradle/charger
OPERATION
CHARGING TOOLS
See Figure 6.
Follow these directions when charging the tools.
The light emitting diode (LED) lights up when the cradle/
charger is properly connected to the power supply.
This light indicates the tools are charging and will remain
on until the cradle/charger is disconnected from
the power supply.
12
N FIN GR H CZ
Press angle adjustment button.
Move head of tool down until it snaps into place.
adjustment button and move head of tool up until
it snaps into place.
Locate a convenient electrical outlet.
to make sure they will not interfere with surrounding
objects.
Place cradle/charger in the desired location.
Mark holes with pencil.
Remove cradle/charger.
Drill four pilot holes.
Position cradle/charger, aligning holes in cradle/charger
with pilot holes.
Secure cradle/charger with four (4) screws provided.
Place screwdriver and flashlight in charging stand
making sure input jack and charger plug are properly
connected.
Align grooves on screwdriver and flashlight with tabs
on charging stand then push on screwdriver and
flashlight to snap into place.
RUS RO PL