Hazards Caused By Repetitive Movements; Hazards Caused By Accessories - Parkside PDBS 1800 A1 Originalbetriebsanleitung

■ Fingers might be crushed in nut wrenches with
an open pan head.
■ Keep your hands away from the rotating collet
chuck and the rotating drill.
■ Do not use the tool in confined spaces and en-
sure that your hands are not crushed between
the machine and the work piece, especially
when removing screws.
■ Safety goggles must be worn. The wearing of
protective gloves and safety clothing is recom-
mended.
■ Use personal protective equipment. Always wear
eye protection. Wearing personal protective
equipment such as protective gloves, non-slip
safety shoes or hearing protection, depending on
the type and use of the tool reduces the risk of
personal injuries and it is recommended.
■ The permissible speed of the accessory tool
used must be at least as high as the maximum
speed specified for the compressed-air tool. Ac-
cessories which rotate faster than the maximum
permissible rate can break and throw pieces
into the air.
■ Wear a safety helmet for overhead work.
■ The tool will run on after the compressed-air
tool has been switched off.
■ Ensure that no hazard is caused by sparks cre-
ated during use. Explosive or flammable dusts
can be generated when processing certain
materials. There is a risk of explosion or fire.
■ 24 │ GB │ IE
Hazards caused by repetitive move-
ments
■ Users of an automatic screwdriver may experi-
ence unpleasant sensations in their hands, arms,
shoulders, neck area or other body parts while
working with the tools.
■ Assume a comfortable position when working
with this machine, pay attention to safe footing
and avoid unfavourable positions or such that
make it difficult to keep your balance. During
work over longer periods, the operator should
change posture to avoid discomfort and fatigue.
■ If the operator notices symptoms such as
persistent discomfort, throbbing, pain, tingling,
burning or stiffness, these warning indications
should not be ignored. The operator should
consult a qualified medical doctor.

Hazards caused by accessories

■ Disconnect the machine from the energy supply
before changing the machine tool or accessory.
■ Do not touch fittings or accessories during
the striking process because this can increase
the risk of cuts, burns or injuries caused by
vibrations.
■ Avoid direct contact with the accessory tool
during and after use because it may be hot or
have sharp edges.
■ Use only accessories and supplies of the sizes
and types recommended by the manufacturer
of machines for screw connections; do not
use any other types or sizes of accessories or
consumable materials.
■ Use only impact fittings that are in good work-
ing order because any defects in the handles
and accessories can cause these to break and
be ejected when used with impact wrenches.
■ The permissible speed of the accessory tool
used must be at least as high as the maximum
speed specified for the compressed-air tool. Ac-
cessories which rotate faster than the maximum
permissible rate can break and throw pieces
into the air.
PDBS 1800 A1