Cleaning Modes - cecotec CONGA 1690 Bedienungsanleitung

• Connect to Wi-Fi
WARNINGS:
• The App does not support 5G networks.
• The Wi-Fi name and password cannot exceed 32 bits.
• If the network configuration fails to connect, follow the below steps:
• Press the start button for 5 seconds, the robot will enter sleeping mode and the Wi-Fi
light indicator will blink fast indicating connection error. Retry connecting the robot again
following the steps in the before section.
• If the connection fails again, check if:
• The robot is too far away from the router.
• The Wi-Fi password is incorrect.
• The Wi-Fi networks is not 2.4G Hz.
* This Conga model is compatible with Alexa and Google home virtual assistants.

CLEANING MODES

The robot offers different cleaning modes which adapt to different cleaning needs.
Auto cleaning mode
From the standby mode, press the auto mode button on the robot, the App or the remote
control for the robot to start cleaning automatically. It will carry out a cleaning cycle in Gyro
mode, Edge mode and then will finish off in Random mode before going back to the charging
base. It is the most commonly used cleaning mode and it is used to clean the 100 % of the
house's surface. The robot vacuums the floor's dust automatically, in and organized and
efficient way, as it features memory and gyroscopic navigation. Moreover, it changes direction
when it finds obstacles throughout its route and it returns to the charging base in a smart and
direct way once the cleaning is over. It includes Total Surface function, therefore the robot
cleans the whole surface, returning to the charging base if necessary until it finishes it. Once
it has completed cleaning, the robot will operate in Random mode until it runs out of battery.
Edge mode
Select this mode from the App or the remote control, the robot will clean along the edges and
will return to the charging base through its smart technology once it has finished. If there is
no charging base, the robot will return to the starting point.
Area mode
Select this mode from the App, the robot will clean a 2*2 m in zag zag motion and will return
to the starting point. The robot will not create any map under this mode.
ENGLISH
31