Inserting The Battery - Hilti PMD 200 Bedienungsanleitung

Bluetooth frequency
Degree of protection (IEC 60529) without battery
Tripod mount (BSW)
System measuring accuracy under favorable conditions*
System measuring accuracy under unfavorable conditions**
Storage temperature
Ambient temperature for operation
Rated voltage
Rated current
Max. site elevation
Max. humidity
4.1 Tablet
The technical data below constitute the minimum requirements for running the PMD 200 application.
Operating system
Bluetooth
Display resolution
4.2 Battery
Battery operating voltage
Ambient temperature for operation
Storage temperature
Battery charging starting temperature
5 Preparations at the workplace
Observe the safety instructions and warnings in this documentation and on the product.
5.1 Charging the battery
1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery.
5.2

Inserting the battery

CAUTION
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
*2275630*
2275630
PMD 200
2,400 MHz ...
2,483.5 MHz
IP 54
5/8 in
±3 mm
(±0.1 in)
±5 mm
(±0.2 in)
−20 ℃ ... 70 ℃
(−4 ℉ ... 158 ℉)
−10 ℃ ... 40 ℃
(14 ℉ ... 104 ℉)
10.8 V
350 mA
2000 m / 6560 ft AMSL
80 %
PMC 200
Android 7.0
BLE
1,920 x 1,200
10.8 V
−17 ℃ ... 60 ℃
(1 ℉ ... 140 ℉)
−20 ℃ ... 40 ℃
(−4 ℉ ... 104 ℉)
−10 ℃ ... 45 ℃
(14 ℉ ... 113 ℉)
English 17