GYS GYSPOT ARCPULL 350 Handbuch Seite 23

DRAWN ARC WELDING WITH THE ARCPULL 350
Check the polarity of the gun dinse cables:
Insert to be welded
Alu pulling ring
Steel pulling ring
Pulling rivet rods
Stud, inner threaded stud, steel
insulation nail, etc.
Threaded stud, inner threaded
stud, alu insulation nail, etc.
Locking scrollwheel for earth
rods:
• Modify the welding settings if necessary (synergic mode or manual mode)
• Unlock the earth rods using the scrollwheel.
• Place the gun on the sheet.
• Create a contact between the insert and the sheet metal. As soon as the gun creates a «beep»
or that the LED contact (blue) is switched on, lock the earth rods using the scrollwheel.
• Press the trigger.
• Once the welding is complete, raise the gun to release the electrode (ring or threaded stud).
At the end of the welding process, the product goes into the standby. During this phase, the gun's ready LED (green)
flashes and the trigger is no longer active. The duration of this phase depends on the duration of the previous weld.
1.5mm pulling ring on 1mm sheet metal
Ø6mm steel threaded stud on 3mm sheet metal
Ø8mm steel threaded stud on 10mm sheet metal
Note 1: It is imperative that the ring weld be carried out with new rings.
Note 2: To ensure the correct positioning of the weld, draw a perpendicular cross on the support sheet metal and make
it coincide with the external markings of the pad.
Note 3: The welding of inserts with a diameter greater than 6 mm must be done horizontally.
Note 4: It is imperative that the pulling rivet rod welding be carried out on a sanded and dust-free rivet. It is recom-
mended to use the earth clamp in order to not prematurely degrade the stainless steel barrel.
Do not over-tighten the gun studs locking scrollwheel of the gun.
GYSPOT ARCPULL 350
• Clean and remove grease from the welding zone.
• Mount the appropriate tool on the gun (ring holder, threaded stud holder, etc.)..
If necessary, mount the pad and its protective cap at the end of the rods, as well
as the barrel and its nozzle.
• Place an insert (pulling ring, threaded studs, etc.) in the gun tool.
Connection of the positive cable
(red)
Negative dinse connector (-)
Positive dinse connector (+)
Negative dinse connector (-)
Positive dinse connector (+)
Positive dinse connector (+)
Example
Negative dinse cable
Positive dinse connector (+)
Negative dinse connector (-)
Using the earth clamp - Connected to the positive dinse
connector (+)
Negative dinse connector (-)
Negative dinse connector (-)
Rest time
3 s
7 s
14 s
EN
Welding rate
19 pieces /min
8 pieces /min
4 pieces/min
23