Care And Storage - Beurer MG 300 Gebrauchsanweisung

4. Rolling massage
Press the rolling button. Then use the full, back or neck button to select the desired massage area.
During the rolling massage you can use the width button to select the distance between the massage
rollers.
If you change the massage type (Shiatsu, swing or rolling massage) the area that was previously selected
is retained. Please note that when you change from spot Shiatsu or swing massage to rolling massage,
you have to select the massage area again.
Note
• Rolling massage and spot massage cannot be selected at the same time.
5. Heating function
Press the heat [15] button to switch on the heating function of the massage heads. The massage heads
light up red at this time.
• Do not use the massage device for longer than 15 minutes and then allow it to cool. Using the device
for longer can over-stimulate the muscles and cause tension instead of relaxation. The massage can be
finished at any time by pressing the
return to the starting position at the lumbar region. This is indicated by the LED flashing. Once this position
is reached, the device switches o .
• If the device is stopped be pressing a massage area button twice, it also returns to the starting position
after 15 minutes and then switches o .
• Do not disconnect the device from the mains supply during operation. Always switch it o first and wait
until it has returned to the initial position.
Note
• The device has an automatic shut-o mechanism set to a maximum operating period of 15 minutes.

8. Care and storage

Cleaning
WARNING
• Disconnect the device before cleaning it.
• Only clean the appliance in the manner specified. Fluid must never be allowed to enter into the
device or accessories.
• Smaller stains can be removed using a cloth or moist sponge together with a little liquid detergent
for delicate fabrics if necessary. Do not use any cleaning agents containing solvents.
• The removable cover is machine-washable at 40ºC. Please note the symbols for care and cleaning
on the label sewn into the cover.
The back mesh cover is attached with a zip above the neck area.
• Do not use the device again until it is completely dry.
Storage
If you do not use the device for longer periods, we recommend storing it in the original packaging in a dry
place without weighting it down.
Alternatively, you can hang the device in a wardrobe with a coat hanger. To do so, the coat hanger must be
threaded through the hanging loops on the rear side of the device.
Ensure that you use a stable clothes hanger made from wood that is able to carry the weight of the device.
CAUTION
• If you use the transport lock screws, take care to remove these before starting the device when you
next use it.
button. Please note that on switching o , the massage heads first
14