Siemens SITRANS Probe LU Kurzanleitung Seite 13

Accessing a parameter
1.
2.
3.
4.
5.
6.
Changing a Parameter Value
Notes:
• Security must be disabled to enable programming: set P000 to the Unlocked Value stored
in P069. (A remote master can still change configuration, if P799 is set to allow this.)
• Invalid entries will be rejected or limited.
• CLEAR
1.
2.
Parameter Reset to Factory Default
1.
2.
Master Reset (P999)
Returns all parameters except P000 and P069 to default settings. (The learned TVT curve is not
lost.)
1.
2.
3.
4.
5.
A5E32168031
Downloaded from www.Manualslib.com
Press PROGRAM then DISPLAY
PROGRAM mode.
Either use the ARROW keys
different parameter, or:
Press DISPLAY to open the Parameter Number
field.
Key in the desired parameter number followed by
ENTER .
For example: press then
The LCD displays the new parameter number and
value.
can be used to clear the field.
Key in the new value.
Press ENTER to set the value.
Scroll to the parameter or enter its address.
Press CLEAR then ENTER
Press PROGRAM then DISPLAY
,
Press DISPLAY to open parameter fields.
Key in 999.
Press CLEAR then ENTER
reset. The LCD displays C.ALL.
Reset complete. (Reset takes several seconds to complete.)
SITRANS Probe LU (HART) – QUICK START MANUAL
manuals search engine
, to activate
to scroll to a
.
. The value returns to the default setting.
to activate PROGRAM mode.
, to Clear All and initiate
PROGRAM Icon
Parameter Number
Parameter Value
current value
Page EN-11