Using The Baby Monitor; Positioning The Baby Monitor; Linking Parent Unit And Baby Unit - Philips AVENT SCD506/05 Bedienungsanleitung

Parent unit
The parent unit runs on two rechargeable 850mAh Ni-MH batteries that are supplied with the baby
monitor. Charge the parent unit before you use it for the first time and when the batteries are low.
1 Make sure that the parent unit is switched off and disconnected from the mains.
2 Remove the lid of the battery compartment (Fig. 7).
3 Insert the rechargeable batteries. Make sure that the + and - poles point in the right direction (Fig.
8).
4 Reattach the lid.
5 Put the power adapter in the parent unit and put the adapter in the wall socket (Fig. 9).
The battery status indicator flashes green to indicate that the appliance is charging.
Note: It takes 4 charge and discharge cycles before the rechargeable batteries reach their full capacity.
The normal charging time is 10 hours, and the normal operating time is 24 hours.
Rechargeable batteries:
Manufacturer
BYD
GPI

Using the baby monitor

Positioning the baby monitor

Keep the baby unit out of the reach of the baby. Never place the baby unit inside the baby's bed or
playpen.
Because the cord of the baby unit presents a potential strangulation hazard, make sure that the baby
unit and its cord are at least 1 metre/3.5 feet away from your baby. (Fig. 10)
To prevent a high-pitched sound from one or both units, make sure the parent unit is at least 1.5
metres/5 feet away from the baby unit.
Note: When the parent unit is out of range of the baby unit, the parent unit beeps from time to time.
The link indicator on the parent unit flashes red.

Linking parent unit and baby unit

1 Press and hold the on/off button on the baby unit for two seconds (Fig. 11).
-
All lights on the baby unit light up briefly.
2 Press and hold the on/off button on the parent unit for two seconds (Fig. 12).
-
All lights on the parent unit light up briefly.
-
The 'link' light flashes red and the parent unit starts to search for the baby unit.
-
When the parent unit and baby unit are linked, the 'link' light turns solid green (Fig. 13).
-
If no connection is established, the 'link' light flashes red and the parent unit beeps from time to
time.
Note: It takes less than 15 seconds to establish the link between the parent unit and the baby unit.
Model
H-AAA850A-MB20
PH85AAAHC
Rating
1.2V Ni-MH AAA/R03 850mAh
1.2V Ni-MH AAA/R03 850mAh
English
9