Connecting Ac Power - Allen-Bradley PanelView 600 Installationsanleitung

Connecting AC Power

The electrical rating for the PanelView 600 terminal is shown below.
Table 1
Terminal Type
PV600
The PanelView 600 terminal is an IEC 1131-2 Equipment Class I device and requires
you to connect the
ATTENTION
WARNING
To connect AC power to the PanelView 600 terminals:
1. Secure the AC power wires to the L1 and L2N screws on the terminal block.
2. Secure the Earth Ground/Protective Earth wire to the
terminal block.
Supply Voltage
85 to 240V ac, 47 to 63 Hz
(Protective Earth) terminal to an earth conductor.
• The PanelView 600 terminal is designed for safe use when
installed in a suitably rated NEMA Type 12, 13, 4X (indoor use
only), IP54 or IP65 enclosure.
• Do not apply power to the terminal until all wiring
connections have been made. Failure to do so may result in
electrical shock.
Explosion Hazard - Do not connect or disconnect equipment
while circuit is live unless area is known to be non-hazardous.
PanelView 600 Terminals
Power Consumption
60 VA maximum
screw on the
Publication 2711-IN010E-MU-P
13