Skil 3153 Originalbetriebsanleitung Seite 7

USE
• Charging battery
! read the safety warnings and
instructions provided with the
charger
• Removing/installing the battery 2
• Battery level indicator 8
- press the battery level indicator
button V to show the current battery
level 8 a
! when the lowest level of the
battery indicator starts flashing
after pressing button V 8 b, the
battery is empty
! when 2 levels of the battery
indicator start flashing after
pressing button V 8 c, the
battery is not within the
allowable operating temperature
range
• Battery protection
The tool is suddenly being switched
off or prevented from being switched
on, when
- the load is too high --> remove
load and restart
- the battery temperature is not
within the allowable operating
temperature range of -20 to
+50°C --> 2 levels of the battery
level indicator start flashing when
pressing button V 8 c; wait until
battery has returned within the
allowable operating temperature
range
- the battery is nearly empty (to
protect against deep discharge)
--> a low battery level or flashing low
battery level 8 b is shown by the
battery level indicator when pressing
button V; charge battery
! do not continue to press the
on/off switch after the tool is
switched off automatically;
battery may be damaged
• Car socket connection 9
- as alternative to a battery pack, the
car socket can be used as power
supply
- remove the car socket adapter T
from the storage compartment W
- connect adapter T to the car socket
• On/off 2
- press button F
- LCD display C will show pressure
information
- by pressing the function button
E you can switch between high
pressure (default) and high volume
function
- press LED button G to turn the work
light on/off
- press button F again to turn off
! after approx. 5 minutes
of inactivity the tool will
automatically turn off
HIGH PRESSURE FUNCTION
• Connecting the air hose q
- unlock the air chuck clamp Y
- place the air chuck X on valve stem
! for Presta and Dunlop valves
screw the adapter L on the valve
stem before placing the air chuck
- push the air chuck down so that the
threaded section of the valve stem is
inside the air chuck
- lock the air chuck clamp Y
• Removing/installing adapters w
- unlock the air chuck clamp Y
- push the adapter into the air chuck
X until it stops
- lock the air chuck clamp Y
• Set target pressure e
! make sure that the high pressure
function is selected e a
- target pressure AB can be
increased and decreased with +
and – buttons A to the desired value
(between 0.2 and 11.0 bar)
- to change the pressure unit AA
press + and – buttons together
! to avoid over inflation, read the
instruction provided with the
items to be inflated and never
exceed recommended pressures
• Inflating
- to start inflating, press button D
- the actual pressure Z is shown
! when the actual pressure is
higher than the target pressure,
the tool will not start inflating
- to pause or stop inflating, press
button D again
- the tool stops when the target
pressure is reached
! allow the tool to cool down for 5
minutes after each 15 minutes of
continuous use
7