NEC MultiSync LCD1810 Serie Benutzerhandbuch Seite 9

Quick Start cont.
3. Remove connector cover on back of monitor (Figure I.1). Connect the BNC cables and AC
adapter cable to the appropriate connectors on the back of the monitor. Connect the blue
BNC cable to the BNC connector labeled B, the green BNC cable to the BNC connector
labeled G/Sync, the red BNC cable to the BNC connector on the monitor labeled R. If you
have a fourth BNC connector (Composite Sync), connect it to the BNC connector on the
monitor labeled HS/CS. If you have a fifth BNC connector (Vertical Sync), connect it to the
BNC connector on the monitor labeled VS (Figure I.1). Place the 15-pin VGA to BNC
Cable under Clip A (Figure J.1A). Then place the 15-pin VGA to BNC cable under Clip B
(Figure J.1B) Replace connector cover.
NOTE: Incorrect cable connections may result in irregular
operation, damage display quality/components of
LCD module and/or shorten the module's life.
4. Connect one end of the power cord to the AC
Adapter and the other end to the power outlet
(Figure K.1).
5. Turn on the monitor (Figure L.1) and the computer.
6. To complete the setup of your MultiSync LCD
monitor:
A. Set the resolution to 1280 x 1024 @ 60 Hz.
NOTE: For download information on the Windows
95/98 INF file for your MultiSync LCD
monitor, refer to the References section of
this User's Manual.
B. Use the following OSM
• Auto Adjust Contrast
• Auto Adjust
• Image Adjust – Fine
NOTE: Manual adjustment of the H/V Position and
Image Adjust H. Size/Fine controls may be
required to complete setup of your MultiSync
monitor. For a full description of these OSM
controls, refer to the Controls section of this
User's Manual.
7. Refer to User's Manual in the NEC LCD Setup
Software CD case for installation and
operation of this software.
NOTE: If you have any problems, please refer to the
Troubleshooting section of this
User's Manual.
Power
Button
Figure L.1
78133813.wpc
®
controls:
™
Clip
A
Figure J.1A Figure J.1B
7
9
HS/CS
VS
R
G(/SYNC)
B
Figure I.1
Figure K.1
Clip
B
10/28/99, 3:21 PM