Bulb Replacement - Ryobi CFP-180SM Bedienungsanleitung

CFP-180SM 2/06/05
GB
F D E
FEATURES
1. Battery Pack (not included)
2. Latches
3. To Remove: Depress Latches To Release Battery Pack
4. Multi-Position Head
5. Switch Trigger
6. Pull Lens Cover Forward To Remove
7. Depress Button
8. Lens Cover
9. Tabs
10. Slot
11. Button
12. Spring
13. Bulb Storage Area
14. Bulb
OPERATION
TO INSTALL BATTERY PACK (NOT INCLUDED)
Place battery pack in your flashlight. Align raised rib
■
on battery pack with groove inside. See Figure 1.
Make sure the latches on battery pack snap in place
■
and battery pack is secured in flashlight before
beginning operation.
TO REMOVE BATTERY PACK (NOT INCLUDED)
Switch off your flashlight.
■
Locate latches of battery pack and depress to release
■
battery pack from your flashlight.
Remove battery pack from your flashlight.
■
ROTATING HEAD
See Figure 2.
Your flashlight has the feature of rotating the head 180°
in either direction.

BULB REPLACEMENT

TO REPLACE BULB
Remove battery pack from worklight. See section "To
■
install/remove battery pack".
Depress button located on top of lens covers then pull
■
lens cover to remove.
Remove old bulb from spring by twisting bulb.
■
Insert new bulb in spring by twisting bulb.
■
16:58 Page 5
I P NL S DK N
English
FIN GR H CZ RUS
Replace lens cover aligning tabs inside lens cover
■
with slots on housing and let the bulb aligning to the
hole canter of the reflector, then snap into place.
Replace battery pack.
■
Note: For your convenience, your flashlight has a
spare bulb storage area. It is located behind the
lens cover. See Figure 3.
WARNING
Do not attempt to disassemble the battery pack.
Fire or injury may result.
MAINTENANCE
WARNING
When servicing, use only identical replacement
parts. Use of any other part may create a hazard
or cause product damage.
Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to damage from various
types of commercial solvents and may be damaged
by their use. Use clean cloths to remove dirt, dust, oil,
grease, etc.
WARNING
Do not at any time let brake fluids, gasoline,
petroleum-based products, penetrating oils, etc.
come in contact with plastic parts. They contain
chemicals that can damage, weaken or
destroy plastic.
Do not abuse power tools. Abusive practices can damage
tool as well as workpiece.
WARNING
Do not attempt to modify this tool or create
accessories not recommended for use with
this tool. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
5
RO PL SLO HR TR