Maintenance And Repair; Maintenance; Repair; Returning The Device - Stahl 8510/1 Serie Betriebsanleitung

9

Maintenance and Repair

9.1

Maintenance

• Consult the relevant national regulations to determine the type and extent of
inspections.
• Adapt inspection intervals to the operating conditions.
At a minimum, check the following points during maintenance work on the device:
• Whether the clamping screws holding the electric lines have been firmly tightened
• Whether the device has cracks or other visible signs of damage
• Compliance with the permissible service temperature (IEC 60079-0)
9.2 Maintenance
Observe the relevant national regulations in the country of use.
9.3

Repair

Explosion hazard due to improper repair!
Non-compliance results in severe or fatal injuries.
• Repair work on the devices must be performed only by R. STAHL
9.4

Returning the Device

• Only return or package the devices after consulting R. STAHL!
Contact the responsible representative at R. STAHL for this.
R. STAHL's customer service is available to handle returns if repair or service is required.
Only return or package the devices after contacting and consulting R. STAHL!
145955 / 8510601300
2016-10-25·BA00·III·en·04
Schaltgeräte GmbH.
Maintenance and Repair
DANGER
Control unit
Series 8510/1
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
11