Safety Instructions - Kostal PIKO 10 Kurzanleitung

Short manual

Safety instructions

DANGER!
RISK OF DEATH DUE TO ELECTRICAL SHOCK AND DISCHARGE
Life-threatening voltages are present in the inverter. Only a qualified electrician may open
and perform work on the device.
Always de-energise the device during installation, maintenance and repairs, and secure
it against being switched back on. Important! After de-energising the device, wait five
minutes for the capacitors to discharge.
The PV generators/cables may be live as soon as they are exposed to light.
DC cables must never be connected to or disconnected from the device during operation,
as dangerous arcs may form. De-energise DC side, then mount or remove plug connector!
WARNING!
RISK OF BURNS FROM HOT PARTS
Allow device to cool before any maintenance or repair work.
RISK OF BURNS FROM HOT PARTS ON THE DEVICE
Some of the inverter components can reach temperatures of over 80°C during operation.
Select the installation site in accordance with the information provided in these
instructions. Always keep the ventilation openings clear.
RISK OF FIRE DUE TO OVERCURRENT AND HEATING OF THE MAINS CABLE
Install line circuit breaker to secure against overcurrent.
RISK OF FIRE DUE TO IMPROPER INSTALLATION
Incorrectly fitted plugs and sockets may heat up and cause a fire. During installation, be
sure to follow the manufacturer's requirements and manual.
WARNING!
INJURIES CAN RESULT FROM DESTRUCTION OF THE DEVICE
When the maximum values for the permitted input voltage at the DC inputs are exceeded,
this can result in serious damage, which may destroy the device and cause serious injury to
any person present. Even briefly exceeding the voltage may cause damage to the device
© 2020 KOSTAL Solar Electric GmbH
DE
CS
DA
EL
EN
ES
ET
FI
FR
IT
NL
PL
PT
SV
TR