Brita PURITY Quell ST Serie Handbuch Seite 25

If anything is missing, please contact your local BRITA Office.
4.2 Assembling the Pressure Vessel and the Pressure Vessel Lid
4.3 Assembly of Inlet and Outlet Hoses
Note: The inlet and outlet hoses are not included in the standard scope of delivery. The use of
BRITA hose sets is recommended (Chapter 13).
• Fit inlet hose
connector head
Note: Inlet "IN" and outlet "OUT" of the connector head
seals, therefore no additional flat seals may be used here. Check that the O-rings are seated
correctly.
Caution: The max. tightening torque at the 1" and 3/4" connections must not exceed 15 Nm!
!
Only hose connections with flat seals may be used. Hoses with conical screwed connections
damage the filter head connections and invalidate any guarantee claims. Only hoses that comply
with DVGW-W 543 may be used to connect the device.
Before assembly, note the direction of flow on the upper side of the filter head, "IN" = water inlet,
"OUT" = water outlet. Prior to installation, note installation dimensions and operating position
(Chapter 12). If no original hoses are used, the 1"–3/4"
the return valve is sealed correctly (pre-fitted in the water inlet).
5 Commissioning a New Filter
5.1 By-pass setting for filter systems without and with measuring and display unit
• For PURITY Quell ST filter systems: identify the local carbonate hardness in degrees of
German hardness °dH (BRITA nomenclature °KH) using the enclosed carbonate hardness test.
• Check the by-pass setting on the by-pass adjuster
Note: A 30% by-pass setting has been made in the factory, and might be changed to suit the
local carbonate hardness or total hardness and the application (Chapter 7).
Downloaded from www.Manualslib.com
• Stand with both feet on the kick loops
• Lift the pressure vessel
are over the kick loops
• Remove the transport protective cap
• Check that the O-ring seal of the filter cartridge
groove and also check for dirt and damage.
Note: the cartridge seat has been lubricated with food-safe lubricant at the
factory.
• Stand on the kick loops
on the pressure vessel
handle must match the "INSERT" groove.
20
• Press the pressure vessel lid
engages.
at the inlet of the connector head
6
.
4
manuals search engine
.
12
and turn it clockwise until the mantle handles
1
.
12
from the filter cartridge.
18
with both feet and place the pressure vessel lid
12
. The position of the arrow marking on the lid
1
down and turn clockwise until the lock
3
and outlet hose
4
are equipped with O-rings as
4
adapter supplied must be used to ensure
17
.
19
is correctly seated in the
2
15
at the outlet of the
10
16
3
EN
23