Klarstein Smartwave Handbuch Seite 21

• Do not use this heater in the immediate surroundings of a bath, shower or swimming
pool.
• This product must not be left outdoors exposed to the elements for long periods of
time.
• Do not touch the plug with wet or damp hands.
• Do not run the power cable under carpeting. Do not cover the power cable with
rugs, runner, or similar coverings. Arrange the power cable away from foot traffic
and where it will not be tripped over.
• Do not wind the power cable around the unit.
• Do not insert or allow foreign objects to enter any ventilation or opening on the
heater, as this may result in electric shock, fire, or damage to the heater.
• To prevent a possible fire, do not block the air vents.
• A heater has hot and arcing or sparking parts inside. Do not use in areas where
petrol, paint, explosive and/or flammable liquids are used or stored. Keep unit
away from heated surfaces and open flames.
• Where possible, avoid the use of an extension cable as this may overheat and
cause a fire. However, if you have to use an extension cable, ensure it is suitable
for the purpose, has been tested for outdoor use and preferably has an RCD device
fitted or attached.
• Always ensure the heater is plugged into a suitable socket, one that is tested for
outdoor use.
• Always unplug the unit and ensure the unit is completely cold before moving, clean-
ing or storing.
• Do not place the device below a socket-outlet.
• The heater is to be installed so that switches and other controls cannot be touched
by a person in the bath or shower.
• This heater is intended for domestic use only and should not be used commercially
for contract purposes. Any alternative use, not recommended by the manufacturer,
may result in fire, electric shock, or injury to persons.
• The use of attachments on the heater is not recommended.
• Do not use this heater with a programmer, timer, separate remote control system or
any other device that switches the heater on automatically, since a fire risk exists if
the heater is covered or positioned incorrectly.
EN
21