Normal Operatingdisplay; Lamp Hours Display; Light Brightness Control; Standby - Sunoptic Surgical Titan x350 Gebrauchsanleitung

6.2.2 NORMAL OPERATINGDISPLAY

Shows total lamp on hours.
The user may adjust the light brightness by touching the minus
controls on thenormal operating displaytouch screen.
NOTE
Touching
(not strobe) flashes the word "STANDBY" on/off in one second Intervals. Touching

STANDBY

value showing on the screen.
The MENUbutton gives the operator access to five functions of information and control.
Repeatedly touching the MENU button will cycle through the five MENU functions, as follows:
LIT-218 SUNOPTIC SURGICAL
(English)
Downloaded from www.Manualslib.com
6.2.2.1 LAMP HOURS
_
6.2.2.2

LIGHT BRIGHTNESS CONTROL

_
The brightness control operates a progressive electro-mechanical shutter. The
lamp is running at full power if the power switch is on no matter where the
brightness control is set.
6.2.2.3 STANDBY
STANDBY dims the light by moving the shutter to fully occlude it and "softly"
again while in STANDBY mode will restore the light to the preset brightness
6.2.2.4

MENU

manuals search engine
Lamp Hours : 950
100
+
MENU STANDBY
Intensity Adjust
Lamp Hours : 950
100
+
MENU STANDBY
Intensity Adjust
®
or plus
Rev. A
Date of Revision: 10/04/17
Page 15 of 148