Basic Operation - Guide
FUNCTION
BUTTON
ACTIVATION
Manual
Press & Release
Mode
Automatic
Press & Release
Mode
Learn Mode
Press & Hold for
5 Seconds until
LED is activated
Motion
N/A
Sensor
Low Battery
N/A
Batteries
N/A
Replaced
Factory Reset
Press & Hold 15
Seconds until
LED is activated
Error
N/A
4-Way Manual Lock
The 4-Way Manual lock allows you to control your cat's access in and out of
your home in either direction. Until your pet is thoroughly familiar with using the
cat flap, it is a good idea to anly use the 4-Way Manual lock in the In or Out
position only (Fig. H).
IC: Canada
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device mu
6
Downloaded from
www.Manualslib.com
LED INDICATOR
ACTION
Red - Solid for 5
Latch will unlock. Use 4-Way Lock
seconds
options for pet access.
Green - Solid for 5
Latch will lock and will only
seconds
be activated by reading a
"programmed" microchip ID.
Red – Solid for up to
Cat flap will exit Learn Mode
60 seconds
once microchip ID is programmed.
Latch will unlock after successful
programming. Repeat for
additional cats.
Green - Solid for the
Motion is detected outside and the
length of activation
cat flap is looking for a microchip
to read.
Red - Flashes every
Replace batteries soon.
10 seconds
Green – 3 quick
Cat flap will enter Automatic
flashes
mode.
Red - 5 quick flashes
Cat flap will enter back into
Automatic Mode and be locked.
All programmed microchip IDs will
be erased from the memory.
Red – Continuous
Remove batteries, wait 30 seconds
quick flashing
then replace batteries. If Red light
continues, contact the Customer
Care Centre. Latch will attempt to
unlock for cat flap to be used in
Manual Mode.
s
t accept any interference, including interference that may cause undesired operation of the device.
manuals search engine
In or Out
Fig. H
Additional Information
For extended information on your PetSafe
and wall installation, helpful training tips, and available accessories, please
visit www.petsafe.com to download the full product Installation Guide.
Important recycling advice
Please respect the Waste Electrical and Electrical Equipment regulations in your country. This equipment
must be recycled. If you no longer require this equipment, do not place it in the normal municipal waste
system. Please return it to where it was purchased in order that it can be placed in our recycling system. If
this is not possible, please contact PetSafe
Battery Disposal
Separate collection of spent batteries is required in many regions; check the regulations in your area
before discarding spent batteries. At the end of the product life, please contact one of our Customer Care
Centres to receive instructions on proper disposal of the battery. Please do not dispose of the battery in
household or municipal waste.
Compliance
Radio Systems Corporation declares under its own responsibility, that the following product is in compliance
with the essential requirements under article 3 of the RED (2014/53/EU) and the RoHS Directive
(2011/65/EU). Unauthorised changes or modifications to the equipment that are not approved by Radio
Systems Corporation may violate EU RED regulations, could void the user's authority to operate the
equipment, and will void the warranty.
Hereby, Radio Systems Corporation, declares that this PPA19-16145 product is in compliance with the
essential requirements and other relevant provisions. The Declaration of Conformity can be found at:
http://www.petsafe.net/customercare/eu_docs.php.
petsafe.com
In only
Out only
Microchip Cat Flap including glass
®
Customer Care Centre for further information.
®
Fully locked