Preparing The Camera; Opening And Closing The Camera - SecaCam Wild-Vision Full HD 5.0 Bedienungsanleitung

Infrared sensor: The passive infrared sensor (PIR) recognizes moving heat
sources and triggers the camera. The sensitivity of the sensor can be set in
the menu.
ON/OFF switch: In the „ON"-position the camera is ready for use (if equip-
ped with batteries and a memory card).
Photo/Video switch: This switch has no function.
LED switch: Use to adjust the flash intensity. In the position „19" only the
upper LED array is used. Usually this flash intensity is sufficient for night shots.
In order to exploit the full range of the flash, you can use the switch position
„40" which will add the lower LED Panel (additionally 21 LEDs).
Color LCD display: Turn on the color LCD display by pressing the button
„OK". You can control the image section, view the images the camera already
shot or - after pressing the „M" button - enter the menu.
Menu entry: With the monitor turned on (switch the camera on, press OK)
you may enter the camera menu by pressing the „M" button.

3. Preparing the camera

3.1 Opening and closing the camera

Opening: To open the camera undo the two locking brackets. The control
buttons are located on the back of the inner camera housing.
Camera
housing
40
2. The SECACAM
Secondary
battery
compartment
Locking
bracket