Maintenance - Rupes LHR 15ES Original-Bedienungs- Und Wartungsanleitung

REPLACING THE BUFFER PAD
Pull the used pad off and apply the new one, pressing it onto
the disc pad.
ACCESSORIES
LHR 21ES: Buffer pads Ø 180 mm for Ø 150 mm pads.
LHR 15ES: Buffer pads Ø 150 mm for Ø 125 mm pads.

MAINTENANCE

All maintenance operations are carried out with the power supply
disconnected.
At the end of each work session, or when required, remove any
dust from the body of the tool using a jet of compressed air,
paying particular attention to the motor ventilation slots.
No other maintenance operations must be undertaken by the
user.
Maintenance and cleaning of the inner parts, like brushes, ball
bearings, gears etc. or others, must be carried out only by an
autorized customer-service workshop.
ELECTRIC SAFETY - LOW TENSION
The tests have been carried out in accordance with the standard:
EN 60745-1 safety of hand-held electric motor operated tools
EN 60745-2-4 particular requirements for polishers other than
disk type.
RADIO SUPPRESSION
The tools are suppressed in accordance for the prevention and
elimination of radio disturbances measured in accordance with
standard: EN55014-1+EN55014-2; EN61000-3-2+EN61000-3-3.
10
NOISE / MEAN ACCELERATION VALUE
The noise level produced and mean quadratic acceleration value
are measured in according with standard:
EN 60745-1
Sound pressure level / Sound power level
L PA L WA
dB(A)
77 88
LHR 15ES
LHR 21ES 77 88
Danger! The indicate measurements refer to new power tools. Daily usa
causes the noise and vibration values to change.
GUARANTEE
All tools manufactured by RUPES Spa are guaranteed for 12
months from the date of purchase against fabrication and material
defects.
All tools must be used only with RUPES original accessories and
spare parts: we refuse all responsibility for damages or accidents
caused by non-observance of this rule which will also cause the
termination of the guarantee.
The guarantee will no longer be valid if the instructions contained in
this booklet are not followed, if the tool is used for purposes other
than that for which it is intended, if it is dismantled, interfered with in
any way or damaged due to neglect.
The guarantee will be made valid by filling-in the form on the
inside back cover of this instruction booklet.
If the tool is found to be defective or malfunctions, it should be retur-
ned carriage free in one piece in its original packing together with
the guarantee certificate to the manufacturer or to one of the Assi-
stance Centres listed in the appendix to this booklet.
The guarantee does not automatically imply replacement of the tool.
RUPES Spa reserves the right to make any technical or design
modification to its products without prior notice.
The manufacturer is not liable for any print errors. This document
voids and replaces previous ones.
3 axis vibration level
a h
Uncer tainty Uncer tainty
2
m/s
3 2,7 1,5
1,7
3 2,7