D. CALORIE FUNCTION.-
This function counts up in steps of one
calorie,
up
to
9999K/calories. Pressing the key for
more than two seconds will reset all of
the values, except those relating to
personal information.
1. Press the key to switch the monitor
on.
E. ODOMETER.-
This function shows you the total
accumulated distance that you have
travelled throughout the exercises.
To reset the total distance travelled
(ODO), take the battery cover off (A),
Fig.1, and remove one of the batteries
to deactivate the monitor, then replace
the battery and the cover (A), Fig.1.
NOTE:
The
automatically reset whenever the old
batteries are replaced with new ones.
TROUBLESHOOTING GUIDE.-
Problem: The display comes on but
only the Time function works.
Solution:
a.- Make sure that the connection
cable is connected.
Problem: The display does not come
on or the displayed segments are very
weak.
a
maximum
ODO
function
Solution:
a.- Check that the batteries are fitted
correctly.
of
b.- Check the battery charge.
c.- If they are run down change them
immediately.
Problem: Display segments of a
function read-out are not visible or
error
messages
function appear.
Solution:
a.- Remove the batteries for 15
seconds and then refit them correctly.
b.- Check the battery charge If they
are run down change the batteries.
c.- If the above steps do not help then
replace the electronic monitor.
Avoid leaving the electronic monitor in
direct sunlight as this might damage
the liquid crystal display. Similarly, do
will
not expose it to water or knocks.
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE .
6
for
a
particular