Thermostat With Remote Control; Room Thermostat With Actuator; Transport And Storage; Installation - oventrop Unibox TQ vario Betriebsanleitung

Unibox TQ vario
Duo connection piece
Protective tube (see illustIllust.
5 auf Seite 24)
4.1 Thermostat with remote
control
You can set the desired room temperature at
the thermostat with remote control. The ther-
mostat detects the room temperature and the
valve opens and closes accordingly.
Graduation figure
0
1
2
3
4
5
4.2 Room thermostat with
actuator
Set the desired room temperature at the room
thermostat. The room thermostat detects the
room temperature and the actuator opens and
closes the valve accordingly.
5.

Transport and storage

Transport the product in its original packaging.
Store the product under the following condi-
tions:
Temperature
-20°C to +60°C
range
Relative air
Max. 95%
humidity
Particles Store dry and free from
dust
Mechanical Protected from mechani-
influences cal agitation
Radiation Protected from UV rays
and direct sunlight
102272980-V01.02.2020
1022655
1501184
Temperature
(Valve fully closed)
7°C (frost protection
position)
12°C
16°C
20°C
24°C
28°C
Transport and storage
Chemical
Do not store together
influences with solvents, chemicals,
acids, fuels or similar
substances
6.

Installation

6.1 General installation advice

Note the following prior to installation:
• The lower edge of the "Unibox TQ vario"
must be at least 20 cm above the finished
floor.
• The front face of the "Unibox TQ vario"
must be level with the finished wall.
Should the wall not have been
finished, take the plaster and tile
thickness into account.
• The opening of the wall box unit must face
downwards.
• The thermostat must not be influenced by
other heat sources.
• Use the enclosed brackets to align and fix
the "Unibox TQ vario".
• There is a blue dot on the wall box unit. A
hole can be drilled at this location in order
to feed through a cable.
• If necessary, use an empty pipe for cable
routing.
NOTICE
Risk of damage due to lubri-
cants
Seals may be destroyed by greasing
agents or oil.
f Do not use any greasing agents or
oil for the installation.
f Flush any dirt particles or grease or
oil residues out of the pipework.
f Consider the latest technical status
(e.g. VDI 2035), when choosing the
operating fluid.
23