Using Fm/Mw/Lw; Storing Manually - Sony MEX-N7300BD Bedienungsanleitung

Receiving stored stations
1
After selecting the desired band,
press a number button (1 to 6).
Setting DAB announcements
If you enable DAB announcements, DAB
announcements can interrupt the currently
selected source.
1
Press MENU, rotate the control dial to
select [GENERAL], then press it.
2
Rotate the control dial to select [SET
ANNOUNCE], then press it.
3
Rotate the control dial to select [SET
ANNC-ON] or [SET ANNC-OFF], then
press it.
Note
During a DAB announcement, the volume is
adjusted to the level set for TA in RDS (page 13).
To listen to the same or similar program
even during weak reception
Set [SET SOFTLINK] to [ON] (page 21).
[FM-LINK] lights up when the corresponding
FM program is being received.
"Hard Link" follows the same program, and
"Soft Link" follows a similar program.
DAB
SOFT
Hard
LINK
Link

OFF

ON
12
GB
FM
Soft Hard Soft
Link Link Link

  

Using FM/MW/LW

Storing automatically (BTM)
1
Press MODE to change the band (FM1,
FM2, FM3 or MW/LW).
2
Press MENU, rotate the control dial to
select [GENERAL], then press it.
3
Rotate the control dial to select [SET
BTM], then press it.
The unit stores stations in order of
frequency on the number buttons.
Tuning
1
Press MODE to change the band (FM1,
FM2, FM3 or MW/LW).
2
Perform tuning.
To tune manually
Press and hold / (SEEK –/+) to
locate the approximate frequency, then
press / (SEEK –/+) repeatedly to
fine adjust to the desired frequency.
To tune automatically
Press / (SEEK –/+).
Scanning stops when the unit receives a
station.

Storing manually

1
While receiving the station that you
want to store, press and hold a
number button (1 to 6) until [MEM]
appears.
Receiving the stored stations
1
Select the band, then press a number
button (1 to 6).