HQ Power VDPDMXC174 Handbuch Seite 7

• Deleting a Step
1. Enable the PROGRAM mode.
2. Select the chase that contains the step you wish to delete.
3. Press the TAP / DISPLAY button, the LCD shows the current step.
4. Press the bank UP / DOWN button and scroll to the step you wish to delete.
5. Press the AUTO / DEL button to delete the step. All LEDs will flash three times indicating the requested
operation has been performed.
• Deleting a Chase
1. Press the button corresponding to the chase you wish to delete.
2. Press and hold down the AUTO / DEL button while holding down the CHASE button. All LEDs will flash three
times indicating that the requested operation has been performed.
• Deleting All Chases
1. With the power off, press and hold down the AUTO / DEL and bank DOWN buttons at the same time.
2. Reapply the power and all chases should be cleared.
e. Joystick / Channel Selection
• Setting-Up the Joystick
1. Press and hold the PROGRAM button until the LED is lit.
2. Press and hold the MODE and FINE buttons simultaneously. The ASSIGN LED should light. If the reverse
LED lights, press FINE and MODE again to enter the ASSIGN mode.
3. Use the bank UP and DOWN keys to select the axis you wish to assign (pan or tilt).
4. Use the TAP / DISPLAY button to select 16 or 8-channel mode.
5. Press the button corresponding to the scanner you wish to assign.
6. While holding the MODE button press the scene number corresponding to the slider which controls the
movement (example: If the pan is controlled by slider number 4, press and hold the MODE button while
tapping scene button 4).
7. When finished press the MODE and FINE buttons simultaneously again to exit ASSIGN mode.
• Reversing the Joystick Movement / DMX Channel
1. Enable the PROGRAM mode.
2. Press the FINE and MODE buttons to enter ASSIGN mode. Press the FINE and MODE buttons again to enter
REVERSE mode. The reverse LED lights up indicating the REVERSE mode is active.
3. Use bank UP / DOWN button to change between the pan and tilt. The corresponding LED lights indicating this
selection.
4. Press the TAP / DISPLAY button to change between 8-channel and 16-channel mode.
5. Press the SCANNER button to select the scanner.
6. While holding the MODE button, press the corresponding SCENE button of the channel you wish to reverse
(example: If you are reversing the scene on one scanner, once you verify that you are in reverse mode and the
tilt LED is lit, check to see which slider the tilt control is on. Hold the MODE button and press the SCENE
button that is same as the slider number for tilt (slider 5 / scene 5)).
7. Continue steps 3 to 7 as needed. You may reverse a maximum of 48 channels for 12 scanners.
• Deleting a Scanner of a DMX Channel
1. Activate the ASSIGN or REVERSE mode.
2. Tap the scanner button to select the scanner you wish to delete.
3. Press the MODE and AUTO / DEL buttons simultaneously. All LEDs will flash three times indicating the
requested operation has been performed.
VDPDMXC174
7 VELLEMAN