Front Panel; Rear Panel - Numark MixTrack Pro FX Benutzerhandbuch

34. Performance Pads: The top row of pads is used to trigger loop points or samples depending
on the Pad mode setting. See
The bottom row of pads is used to trigger Stutter, Previous Track, Search Backward, and
Search Forward:
•
Stutter: Repeats or "stutters" the sample when the pad is repeatedly tapped.
•
Previous Track: Goes to the previous track.
•
Search Backward: Searches backward through the current track.
•
Search Forward: Searches forward through the current track.
35. Loop On/Off: Press to activate auto loop on/off. Hold Shift and press this button to trigger a
reloop.
36. Loop 1/2: Press this button when a loop is active to decrease the loop size by half. Hold Shift
and press this button to set the Loop In point.
37. Loop x2: Press this button when a loop is active to double the loop size. Hold Shift and press
this button to set the Loop Out point.

Front Panel

1. Headphone Output: Connect headphones to these
1/4" (6.35 mm) and 1/8" (3.5 mm) jacks for
monitoring the signal. The headphone volume is
controlled using the Cue Gain knob.

Rear Panel

1. Master Output (RCA): Use standard RCA cables to
connect this output to speakers or an amplifier
system.
2. USB: Sends USB MIDI data to control various
software parameters.
3. Microphone Input: Connect a standard dynamic
microphone to this 1/4" (6.35 mm) jack.
Operation > Performance Pad Modes for more information.
1
1
2 3
5