Front Panel - Numark NS7 II Benutzerhandbuch

Front Panel

7
9 10 11
1. Headphones (1/4" or 1/8"): Connect your 1/4" or 1/8" headphones to this output for cueing
and mix monitoring.
2. Headphone Volume: Adjusts the volume level of the headphone output.
3. Split Cue: When this switch is in the On position, the headphone audio will be "split" such
that all channels sent to Cue are mixed to mono and applied to the left headphone channel
and the Program mix is mixed to mono and applied to the right channel. When the switch is in
the Off position, Cue and Program audio will be "blended" together.
4. Cue Blend: Turn to mix between Cue and Program in the Headphone channel. When all the
way to the left, only channels routed to Cue will be heard. When all the way to the right, only
the Program mix will be heard.
5. Crossfader Assign: Routes the audio playing on the corresponding channel to either side of
the crossfader (A or B), or bypasses the crossfader and sends the audio directly to the
Program Mix (center, Off).
6. Crossfader Slope: Adjusts the slope of the crossfader curve. Turn the knob to the left for a
smooth fade (mixing) or to the right for a sharp cut (scratching). The center position is a
typical setting for club performances.
7. Mic 1 Input (1/4"): Connect a 1/4" microphone to this input. This input's audio signal is
routed directly to the Program Mix and Cue Mix.
8. Mic 1 On/Off: When set to On, the Mic 1 Input is active, and its audio signal is routed directly
to the Program Mix and Cue Mix. When set to Off, the Mic 1 Input is disabled.
9. Mic Gain: Adjusts the gain of the microphone channel.
10. Mic Bass: Adjusts the low (bass) frequencies of the audio signal coming from the
microphone input.
11. Mic Treble: Adjusts the high (treble) frequencies of the audio signal coming from the
microphone input.
8 5 5 6 5 5
13
4 3 2 1 1