HQ Power VDPL1801MHW10 Bedienungsanleitung Seite 6

e. DMX512 Chain with Termination
f. Projector DMX Start Address Selection
All DMX-controlled devices need a digital start address so that the correct device responds to the signals. This start
address is the channel number from which the device starts to "listen" to the DMX controller. Enter the correct
number and read it from the display located on the base of the VDPL1801MHW10.
You can use the same starting address for a whole group of devices or enter an individual one for every device.
When all devices have the same address, all the VDPL1801MHW10s will "listen" to the control signal on one
particular channel. In other words: changing the settings of one channel will affect all devices simultaneously. If you
set different addresses, each device will "listen" to a separate channel number. Changing the settings of one channel
will only affect the device in question.
In the case of the 11-channel VDPL1801MHW10, you will have to set the start address of the first
VDPL1801MHW10 to 1, the second VDPL1801MHW10 to 12 (1 + 11), the third to 23 (12 + 11) and so on.
g. Function Selection
• Basic Functions
The moving head features an LCD display and 4 control buttons.
{MODE} Scroll through the main menu or exit from the current submenu
{UP} Scroll UP through the menu list or increase the value of the current function
{DOWN} Scroll DOWN through the menu list or decrease the value of the current function
{ENTER} Enter the currently selected menu or confirm the current function value
• Menu
VDPL1801MHW10
A DMX terminator is recommended for installations where the DMX cable has to run a
long distance or is in an electrically noisy environment (e.g. discos). The terminator
prevents corruption of the digital control signal by electrical noise. The DMX terminator is
simply an XLR plug with a 120 resistor between pins 2 and 3, which is then plugged into
the XLR output socket of the last device in the chain.
Please see illustrations.
6 HQPOWER