Stiga Park 4WD serie Gebrauchsanweisung Seite 69

(Translation of the Original Instructions)
8 The engine is running, the
"Battery" indicator and the
text on the digits flashes in-
dicating a voltage below 12V
Compare la scritta "BATT"
(340 IX)
9 Difficulty in engine start-up or
engine runs irregularly
10 Drop in engine performance
during cutting
11 The battery indicator does
not go off after a few minutes
of operation (740 IOX, 540 IX)
12 The oil indicator comes on
during operation (740 IOX,
540 IX)
13 The engine stops for no appa-
rent reason
14 Uneven cutting
15 Abnormal vibration during
use
16 With the engine running, ac-
tivation of the traction pedal
does not move the machine.
If problems persist after the operations above have been performed, contact your dealer.
Warning! Never attempt to carry out complicated repairs without the necessary tools or
technical ability Any poorly performed interventions will automatically nullify the warranty
and exonerate the manufacturer from all liability
ENGLISH
If the condition persists:
Charge fuse (25A) blown.
Faulty battery.
Faulty battery charger.
Carburetion problems.
Forward speed too high in relation to
the cutting height.
Insufficient recharge.
Engine lubrication problems.
- Fuel tank empty.
- Try to restart the engine.
The cutting mean sharpness level
is low.
Forward speed too high in relation to
the height of the grass being cut.
The cutting means assembly is full
of grass.
- Unbalanced cutting means.
- Loose cutting means.
- Loose components.
- Possible damage.
"Disengage transmission" lever in
the disengaged position.
Replace the fuse.
Replace the battery.
Contact an authorised assistance
centre.
Clean or replace the air filter.
Reduce the forward speed and/or
raise the cutting height.
Contact an authorised assistance
centre.
- Turn the machine off immediately.
- Top up the oil level (if the problem
persists, contact an authorised
assistance centre).
Fill the fuel tank (if the problem
persists, contact an authorised
assistance centre).
Check the tyre pressure
Contact an authorised assistance
centre.
Reduce the forward speed and/or
raise the cutting height.
- Wait for the grass to dry.
- Clean the cutting means assembly.
Contact an authorised assistance
centre for inspection, replacement or
repair operations.
Engage the transmission.
EN
27