Cleaning And Maintenance - Concept VP9181 Bedienungsanleitung

CHECKING THE DUST COLLECTION BAG FILL
When the dust collection bag fill indicator turns red during operation, replace the full dust collection bag immediately.
If the dust collection bag fill indicator is still red after the bag has been replaced, this may be due to several causes:
- some of the air passages (hoses, telescopic tube, suction inlet, brush adapter, or other adapters) are obstructed;
- the motor filter is dirty;
- the air outlet filter is dirty.
Check for each of the possible causes above and eliminate the problem before you start vacuuming. If the cause of the
problem cannot be identified, hand over the product to the nearest service centre. Never use the vacuum cleaner if the
bag level indicator is completely red during operation. The motor could be damaged irreparably

CLEANING AND MAINTENANCE

You may clean the accessories and the appliance with a wet cloth. Never immerse
the appliance in water! Do not use any aggressive substances for cleaning, such as
solvents or abrasives!
REPLACING THE DUST COLLECTION BAG
1. Unplug the product from the mains. Disconnect the hose from the suction inlet
and open the appliance cover.
2. Push the flap on the dust retention bag holder; remove the used dust retention
bag (Fig. 3). Dispose of a paper or SMS dust collection bag. Be careful not to tear
the bag when handling. If the bag is made of fabric, empty it and close it
carefully - it can be used repeatedly.
3. Insert a new or empty dust retention bag by fitting the plate in the bag holder. The
bag opening must be aligned with the hose hole in the appliance cover.
4. Never use the vacuum cleaner without the dust bag installed! If you forget to
insert the dust retention bag or you insert it incorrectly, the appliance's motor
may become damaged.
5. Close the cover. Press until you hear a click.
REPLACING FILTERS
• The filters should be cleaned or replaced when they are visibly dirty, or if the
appliance's suction power is reduced. Always check the filters after using the
appliance.
• In order to avoid damage to the appliance, do not use it with incorrectly installed
filters.
• Before replacing the filters, disconnect the appliance from the electrical socket.
• You can buy suitable types of filters from your dealer, or you can order them from
the manufacturer.
CLEANING AND REPLACEMENT OF THE MOTOR FILTER
1. Disconnect the flexible hose and open the appliance cover.
2. Pull the dust collection bag out of its holder so that you can access the motor filter
more easily.
3. Remove the motor filter (Fig. 4). You can clean the filter by tapping it. If the filter is
heavily soiled, you may wash it in lukewarm water and let it dry properly.
4. Insert the cleaned or new motor filter into the appliance and close the cover.
28
EN
(Fig. 3)
(Fig. 4)
VP9181