Safety Advice Relating To Cordless Drill Drivers; Attention - Service Lines; Original Ancillaries / Accessories; Before First Use - Parkside PABS 18 A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

General safety advice for electrical power tools / Before first use
additional medical help if any of the
fluid gets into your eyes. Escaping battery
fluid may cause skin irritation or burns.
Safety advice relating
to cordless drill drivers
½
Securely support the workpiece. A workpiece
held in a clamp or vice is kept more securely in
place than one held by your hand.
WARNING!
Harmful / noxious dusts generated from your
work represent a risk to the health of the person
operating the device and to anyone near the
work area.
½
Do not drill any material containing
asbestos. Asbestos is a known carcinogen.
½
Hold the electrical power tool firmly.
High reaction torques may occur momentarily
during tightening or loosening of screws.
½
If the inserted tool jams, switch off the
electrical power tool immediately. Be
prepared for high reaction torques as they may
cause kickback. The inserted tool may jam if
the electrical power tool is overloaded or is
held at an angle to the workpiece.
WARNING!
strike concealed electricity cables,
therefore when working you must
hold the electrical power tool by the
insulated handle areas only. Contact
with a live wire means that the metal parts of
the electrical power tools may become live and
this can result in an electric shock.
½
Before you carry out any tasks on the
device, transport or store it, make
sure that the direction of rotation
switch is in the middle position (lock).
To prevent the device from starting up uninten-
tionally.
10 GB/IE/CY
Downloaded from www.Manualslib.com
POISONOUS DUSTS!
Wear safety glasses and a dust
mask!
The inserted tool may
manuals search engine
©

Attention - Service lines!

DANGER! Take steps to ensure that
you do not hit upon any service lines
(electricity, gas, water) when work-
ing with electrical appliances. Check, if
need be with a service line detector, before
you start to cut or bore into a surface.
©
Original ancillaries /
accessories
½
Use only the ancillaries and accessories
that are detailed in the operating
instructions. The use of ancillaries and ac-
cessories other than those recommended in the
operating instructions could lead to an in-
creased risk of personal injury for you.
©
Before first use
©

Charging the battery pack

½
DANGER OF ELECTRIC
WARNING!
SHOCK! Before cleaning or servicing the
charging station or the battery pack always
ensure that the plug is not in the mains socket.
Note! A new battery pack, or one that has not
been in use for an extended period, must be charged
up before the first / renewed usage.
The battery pack attains its full capacity after ca.
3-5 charging cycles.
CAUTION! Always ensure the plug is removed
from the mains socket before inserting a battery pack
into, or removing one from, the charging station.
½
Never charge the battery pack if the ambient
temperature is less than 10 °C or greater than
40 °C.
1. Insert the battery pack
charger (see Fig. C).
10
into the quick-
7