Technical Data; General Safety Advice For Electrical Power Tools; Workplace Safety; Electrical Safety - Parkside PEC 200 SE Bedienungs- Und Sicherheitshinweise

1 Knife / Scraper attachment (straight)
1 Spatula attachment
1 Chisel attachment
1 Operating manual

Technical Data

Q
Rated voltage:
Nominal power consumption: 200 W
Nominal stroke rate:
Stroke:
Protection class:
Noise and vibration data:
Values determined in accordance with EN 60745.
The sound pressure level (A-weighted) of the device
is typically 78 dB (A). Uncertainty K = 3 dB. The
sound level while working can exceed 85 dB (A).
Wear ear protection!
Evaluated acceleration, typical:
Hand / arm vibration a
Uncertainty K = 1,5 m / s
WarNING!
instructions has been measured in accordance with
a standardised measurement procedure specified
in EN 60745 and can be used to compare devices.
Different uses of the device give rise to different vibra-
tion levels and in many cases they may exceed the
values given in these instructions. It is easy to underes-
timate the vibration load if the electrical power tool is
used regularly in particular circumstances.
Note: If you wish to make an accurate assessment
of the vibration loads experienced during a particu-
lar period of working, you should also take into
account the intervening periods of time when the
device is switched off or is running but is not actually
in use. This can result in a much lower vibration
load over the whole of the period of working.
Downloaded from www.Manualslib.com
Introduction / General safety advice for electrical power tools
230 V ~ 50 Hz
Level I: n 6.500 min
0
Level II: n 7.500 min
0
Level III: n 8.500 min
0
ca. 2 mm
II /
= 8 m / s
2
h
2
The vibration level given in these
manuals search engine
General safety advice for
electrical power tools
WarNING! read all the safety advice
and instructions!
Failure to observe the safety advice and instructions
may result in electric shock, fire and / or serious injury.
KEEP ALL THE SAFETY ADVICE AND INSTRUC-
TIONS IN A SAFE PLACE FOR FUTURE REFER-
-1 ENCE! THE TERM "ELECTRICAL TOOL" USED
IN THE SAFETY ADVICE REFERS TO ELECTRICAL
-1
TOOLS POWERED BY MAINS ELECTRICITY (BY
-1
MEANS OF A MAINS LEAD) AND ELECTRICAL
TOOLS POWERED BY RECHARGEABLE BATTER-
IES (WITHOUT A MAINS LEAD).

1. Workplace safety

a) Keep your working area clean and
well lit. Untidy or poorly lit working areas
can lead to accidents.
Do not work with the device
b)
in potentially explosive envi-
ronments in which there are
inflammable liquids, gases or dusts.
Electrical power tools create sparks, which can
ignite dusts or fumes.
Keep children and other
c)
people away while you are
operating the electrical tool.
Distractions can cause you to lose control of
the device.

2. Electrical safety

To avoid danger to life from
electric shock:
a) The mains plug on the device must match
the mains socket. The plug must not
be modified in any way. Do not use
an adapter plug with devices fitted
with a protective earth. Unmodified
plugs and matching sockets reduce the risk of
electric shock.
GB/IE 7