Safety And Environment - AKG WMS470 Bedienungsanleitung

WMS470_F031016_Hex_final 22.12.2010 14:19 Uhr Seite 26 (Schwarz/Black Auszug)

1 Safety and Environment

Safety
Environment
The HT 470 D5, HT 470 C5, and PT 470 have been tested and found to comply with the limits for a low-power auxiliary station pursuant to Part 74 of the FCC Rules. The SR 470 has been tested
and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be deretmined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Shielded cables and I/O cords must be used for this equipment to comply with the relevant FCC regualations.
Changes or modifications not expressly approved in writing by AKG Acoustics may void the user's authority to operate this equipment.
The SR 470 complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Most users do not need a license to operate this wireless microphone system.
Nevertheless, operating this microphone system without a license is subject to
certain restrictions: the system may not cause harmful interference; it must operate at a low power level ( not in excess of 50 milliwatts); and it has no protection from interference reveived from any
other device.
Purchasers ashould also be aware that the FCC is currently evaluating use of wireless microphone systems, and these rules are subject to change. For more information, call the FCC at 1 -888-
CALL-FCC (TTY: 1 -888-TELL-FCC) or visit the FCC's wireless microphone website at www.fcc.gov/cgb/wirelessmicrophones.
"This device contains licence-exempt transmitter(s)/receiver that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following
two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device."
26
• Do not expose it to direct sunlight, excessive dust, moisture, rain, mechanical vibrations, or shock.
• Do not spill any liquids on the equipment and do not drop any objects through the ventilation slots
in the equipment.
• The equipment may be used in dry rooms only.
• Before connecting the equipment to power, check that the AC mains voltage stated on the included
power supply is identical to the AC mains voltage available where you will use the equipment.
• Operate the equipment with the included power supply with an output voltage of 12 VDC only. Using
adapters with an AC output and/or a different output voltage may cause serious damage to the
equipment.
• The equipment should be opened, serviced, and repaired by authorized personnel only. The equip-
ment contains no user-serviceable parts.
• Operate the equipment off voltages between 90 VAC and 240 VAC only. Using a different power volt-
age may cause serious damage to the unit!
• If any solid object or liquid penetrates into the equipment, shut down the sound system immediately.
Disconnect the power cable from the power outlet immediately and have the equipment checked
by AKG service personnel.
• Do not place the equipment near heat sources such as radiators, heating ducts, or amplifiers, etc.
and do not expose it to direct sunlight, excessive dust, moisture, rain, mechanical vibrations, or
shock.
• To avoid hum or interference, route all audio lines, particularly those connected to the microphone
inputs, away from power lines of any type. If you use cable ducts or conduits, be sure to use sep-
arate ones for the audio lines.
• Clean the equipment with a moistened (not wet) cloth only. Be sure to disconnect the equipment from
the power outlet before cleaning the equipment! Never use acidic or scouring cleaners or cleaning
agents containing alcohol or solvents since these may damage the enamel and plastic parts.
• Use the equipment for the applications described in this manual only. AKG cannot accept any lia-
bility for damages resulting from improper handling or misuse.
• Be sure to dispose of dead batteries as required by local waste disposal rules. Never throw batter-
ies into a fire (risk of explosion) or garbage bin.
• The packaging of the equipment is recyclable. Dispose of the packaging in an appropriate con-
tainer provided by the local waste collection/recycling entity and observe all local legislation relat-
ing to waste disposal and recycling.
• When scrapping the equipment, remove the batteries, separate the case, circuit boards, and cables,
and dispose of all components in accordance with local waste disposal rules.
FCC Statement
USA only: FCC CONSUMER ALERT
RSS-GEN 8.4 STATEMENT
WMS 470