Debris Container Emptying; After Using The Machine; Pushing The Machine; Machine Long Inactivity - Nilfisk-Advance SWEEPER SW 700S P Betriebsanleitung

ENGLISH

DEBRIS CONTAINER EMPTYING

1. Stop the machine by releasing the drive lever (4).
2. Turn the ignition key (61) to "0".
3. Turn on the fi lter shaker with the handle (20).
4. Disengage the debris container hook (18) by pulling its lower end.
5. With the handle (19) remove the debris container (17) and empty it into an appropriate container.
6. Install the debris container (17) and engage the hook (18).
7. Restart the engine.
8. The machine is ready to start working again.

AFTER USING THE MACHINE

After working, before leaving the machine, perform the following procedures.
1. Clean the dust fi lter by using the manual fi lter shaker (20).
2. Empty the debris container (17) (see the procedure in the previous paragraph).
3. Lift the side broom with the knob (12).
4. Remove the ignition key (71).
5. Make sure that the machine cannot move independently.
6. If equipped, press the pedal brake (26).
7. Close the fuel tap (48) in the compartment (29).

PUSHING THE MACHINE

The machine can be pushed both with the ignition key (71) to "0" and to "I".

MACHINE LONG INACTIVITY

If the machine is not going to be used for more than 30 days, proceed as follows:
1. Check that the machine storage area is dry and clean.
2. Slightly lift the machine so that the skirts, the main broom and the wheels do not touch the ground.
3. Handle the petrol engine as shown in the relevant Manual.

FIRST PERIOD OF USE

After the fi rst period of use perform the following procedures:
1. After the fi rst 8 hours, check the machine fastening and connecting parts for proper tightening and check the visible parts for
integrity and leakage.
2. After the fi rst 20 hours, or after the fi rst month, change the engine oil (see the procedure in the Petrol Engine Manual).

MAINTENANCE

The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following table provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be defi ned by the person in charge of the maintenance.
All scheduled or extraordinary maintenance procedures must be performed by qualifi ed personnel, or by an authorised Service
Center.
This Manual describes only the easiest and most common maintenance procedures.
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be consulted
at any Service Center.
WARNING!
To perform maintenance procedures, the machine must be off and, if necessary, the batteries must be
disconnected.
Moreover, carefully read all the instructions in the Safety chapter before performing any maintenance procedure.
12
Downloaded from www.Manualslib.com
USER MANUAL
146 0676 000(5)2007-06 A
manuals search engine
SW 700S P