Hazards Caused By Repetitive Movements; Hazards Caused By Accessories; Hazards In The Workplace; Hazards Caused By Dust And Vapours - Parkside PDSS 310 B5 Originalbetriebsanleitung

■ Prevent unintentional starting . If the air supply is
interrupted, switch off the compressed air tool
using the on/off switch .
■ In cases where aids are needed to absorb the
reaction torque, we recommend using a suspen­
sion unit wherever possible . If this is not possible,
side handles for machines with a straight grip
and machines with a pistol grip are recommend­
ed . We recommend always using aids to ab­
sorb the torque if it is higher than 4 Nm on
machines with straight grips, higher than
10 Nm on machines with a pistol grip, and
higher than 60 Nm on offset screwdrivers .
■ Release the start/stop control in the event of
an disruption to the electricity supply .
■ Use only the lubricants recommended by the
manufacturer .
■ Fingers can be crushed in nut wrenches with an
open pan head .
■ Keep your hands away from the rotating collet
chuck and the rotating drill .
■ Do not use the tool in confined spaces and
ensure that your hands are not crushed between
the machine and the work piece, especially
when removing screws .
Hazards caused by repetitive
movements
■ Users of an automatic screwdriver may experi­
ence unpleasant sensations in their hands, arms,
shoulders, neck area or other body parts while
working with the tools .
■ Assume a comfortable position when working
with this machine, ensure that you have a firm
footing and avoid unfavourable positions or
positions in which it is difficult to keep your
balance . When working for longer periods, the
operator should change posture regularly, to
prevent discomfort and fatigue .
■ If the operator notices symptoms such as persis­
tent discomfort, throbbing, pain, tingling, burn­
ing or stiffness, these warning indications should
not be ignored . The operator should consult a
qualified medical doctor .
PDSS 310 B5

Hazards caused by accessories

■ Disconnect the machine from the energy supply
before changing the machine tool or accessory .
■ Do not touch fittings or accessories during the
impact process because this can increase the
risk of cuts, burns or vibration injuries .
■ Use only accessories and supplies of the sizes
and types recommended by the manufacturer
of machines for screw connections; do not use
any other types or sizes of accessories or con­
sumable materials .
■ Use only impact fittings that are in good working
order, as any defects in the handles and
accessories can cause these to break and be
flung out when used with impact wrenches .

Hazards in the workplace

■ Slipping, tripping up and falling are the main
causes of injuries in the workplace . Pay atten­
tion to surfaces that may have become slippery
from the use of the machine and also be aware
of tripping hazards caused by air hoses or
hydraulic hoses .
■ Proceed with caution in unknown surroundings .
Concealed hazards caused by power or other
supply lines may be present .
■ This compressed air tool is not intended for use
in explosive atmospheres and is not insulated
against contact with electrical power sources .
■ Ensure that there are no electric cables, gas
pipes, etc . that could cause a hazard if dam­
aged by using the machine .

Hazards caused by dust and vapours

■ The dust and vapours that are produced by
using a machine for screw connections can be
hazardous to health (e .g . cause cancer, birth
defects, asthma and/or dermatitis) . It is essen­
tial to carry out a risk assessment with regard to
these risks and implement appropriate regulato­
ry mechanisms .
■ The risk assessment should include the dust
caused by using the machine and any existing
dust that may be raised at the same time .
GB │ MT │ 55 ■