Coupling Two Racks - Dell PowerEdge 4820 Installationsanleitung

Coupling Two Racks

WARNING:
couple two rack cabinets by yourself.
1 Unpack and set up both racks.
2 Unpack the coupling kit, shown in Figure 1-18.
The contents of the rack coupling kit include:
•
•
Figure 1-18. Rack Coupling Kit
1 gasket strip
3 Remove the doors and side panels from both racks. See "Removing the
Front Door" on page 8, "Opening and Removing the Back Doors", and
"Removing and Replacing the Side Panels" on page 12.
4 Cut and place a segment of the gasket strip, with its protective backing
removed, on one of the racks along the frame surface to be in contact with
the adjacent rack (see Figure 1-19).
32
Downloaded from www.Manualslib.com
Because of the size and weight of the rack cabinets, never attempt to
One gasket strip
Four coupling brackets
1
NOTE:
It does not matter on which rack you place the gasket strip segments,
as long as they protect both racks from being scratched.
Installation Guide
manuals search engine
2
2 coupling bracket (4)