Axis Q1615-E Installationsanleitung Seite 23

Replace the lens
1. Stop all recordings and disconnect power from the product.
2. Disconnect the lens cable and remove the standard lens.
3. Attach the new lens and connect the lens cable.
4. Reconnect the power.
5. Log in to the product's webpage, go to the Image tab and then select the P-Iris lens
you have installed.
Note
If you use a DC iris lens, select Generic DC Iris.
6. For the changes to take effect, you need to restart the device. Go to System >
Maintenance and click Restart.
7. Adjust the zoom and focus.
Adjust zoom and focus for optional lenses
If the camera is mounted so that you cannot look at the image and access the lens at the same
time, use the Focus Assistant, see Focus assistant for optional lenses on page 23.
Note
Only valid for optional P-iris, DC-iris or manual iris lenses.
1. Go to Settings > Image > Focus.
2. Click Fine-tune.
3. Adjust the autofocus area to cover the part of the image that you want to be in focus.
If you don't select an autofocus area, the camera focuses on the entire scene. We
recommend that you focus on a static object.
4. Click Reset focus.
5. Loosen the zoom and focus pullers on the lens by turning them counter-clockwise.
6. Move the zoom and focus ring to set zoom and focus and check the image quality in
the image window.
7. Re-tighten the zoom and focus pullers when satisfied with the image focus.
8. If the image focus has slightly changed while tightening the zoom and focus pullers,
click Fine-tune.
9. If you want to slightly adjust the focus position, move the Focus position slider.
Focus assistant for optional lenses
Note
• Only valid for optional P-iris, DC-iris or manual iris lenses.
AXIS Q1615-E Mk II Network Camera
23
EN